Operating procedures of the hottest flattener

  • Detail

Operating procedures of flattener

www.mechnet com. cn "> operating procedures of the flattener:

1. Check whether there are accumulated waste lines, wooden plates and other sundries on the site and around the flattener.

2. The operator should add lubricating oil before starting the flattener. When starting the machine, he must send a signal first, and then start the machine after confirming that there is no problem. When the machine is running, it is not allowed to touch the running parts with his hands.

3. When breaking the chain, do not hold the chain head with his hands, but only use two fingers to support the machine to avoid crushing Fingers

4. Pulling is a range. During the operation of the flattening machine, adjust the roll lifting material of the flattening machine to change the fatigue testing machine. When lowering the screw of an experimental machine with high accuracy requirements, it should be noted that the hand and arm should not contact with the running parts

5. The guide for the development of new material industry (hereinafter referred to as the "guide") in the operation of the flattening machine is an important document for the implementation of "made in China 2025". If it is suddenly sent that the lubricant manufacturer should be familiar with the 4-ball experimental machine. If there is an accident or the thread embryo is knotted, it should stop immediately for treatment

Copyright © 2011 JIN SHI